Ip nat inside source route-map provider interface FastEthernet4 overload Ip http timeout-policy idle 60 life 86400 requests 10000 License udi pid CISCO881-SEC-K9 sn FCZ151492SDĭescription $ETH-SW-LAUNCH$$INTF-INFO-HWIC 4ESW$ Subject-name cn=IOS-Self-Signed-Certificate-458237257Ĭrypto pki certificate chain TP-self-signed-458237257Ĭertificate self-signed 01 nvram:IOS-Self-Sig#4.cer Let’s find out how the ip nat outside source command works.Crypto pki token default removal timeout 0Ĭrypto pki trustpoint TP-self-signed-458237257 The source IP address 192.168.1.1 is translated to 192.168.2.00 when it travels from the inside to the outside. Success rate is 100 percent (1/1), round-trip min/avg/max = 6/6/6 ms Sending 1, 100-byte ICMP Echos to 192.168.1.1, timeout is 2 seconds: The source IP address is translated from 192.168.1.1 to 192.168.2.200 when the return IP packet travels from the inside to the outside.Ĭan I ping the 192.168.1.1 IP address from H2? Let’s find out: H2# ping 192.168.1.1 repeat 1.The destination IP address is translated from 192.168.2.200 to 192.168.1.1 when the IP packet travels from the outside to the inside.Success rate is 100 percent (1/1), round-trip min/avg/max = 5/5/5 ms ![]() ip virtual-reassembly max-reassemblies number max-fragments number timeout seconds drop-fragments Example: Router (config-if) ip virtual-reassembly max-reassemblies 64 max-fragments 16 timeout 5. Sending 1, 100-byte ICMP Echos to 192.168.2.200, timeout is 2 seconds: Configures an interface type and enters interface configuration mode.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |